· Row arrangement is independent from the grid of the roof substructure
· Considerably less extra load is necessary for loading solutions
· Loads are evenly distributed into the roof construction
and pitched roofs, especially for bridging big distances
between purlins.
DN0 to DN2.5 which can be used as distribution beams
innorth-south direction. Therefore, the most economic
solution can be compiled for any mounting application
respectively for any span length.
drillings at all have to bemade on the construction site!
Support top parts (consisting of module girder plus rear
support) are mounted onto the double-groove profiles using fitting kits.
Instead of elevated systems, the CompactVario system can also be mounted parallel to the roof. In this
case the support top parts are replaced by special cross connector plates.
CompactVario is a very universal system, which allows elevations on almost all kinds of purlin roofs!
The stuctural plant dimensioning of all length spans and width spans as well as the fixation elements
that are used in the respective case is carried out by means of a special statics project planning program.
running in northsouth direction which are suitable for
the fixation of module elevations.
In these cases a fastening similar to CompactVario, but
with horizontal continuous beams can be used.
The system is also reasonable if the necessary number
of fastening points on the roof cannot be reached by
means of supports or if a better distribution of the
fastening points is necessary because of a limited
firmness of the roof covering (for example on sheet
metal roof