litres per minute of hot water provided an adequate supply is
available. The minimum recommended supply should be 1.5 bar
and a flow rate of 25 litres per minute.
be connected to a gas or oil-fired boiler, ideally condensing. The
primary circuit must be pumped rather than gravity fed, but can
be either open vented or sealed.
providing the structure it will be sat on is capable of holding the
weight of a cylinder filled with water.
Cold water inlet and hot water draw-off - 22mm
Coil flow and return - 22mm
Temperature and pressure relief - 1/2" Inlet group - 22mm
Inlet: 15mm
Cylinder capacities 200 litres and above come with a dedicated
secondary return connection. For smaller cylinders, it is possible
to use a swept tee on the cold-water inlet to provide the same.