10
WOOD DOCK HARDWARE
We are the manufacturer of all our galvanized steel wood dock components.
WD-TM
Single "T" Male
3 lbs.
Has one 3/4" tab and is used with Outside Corner Female
or Single "T" Female connectors. The tabs are pre-drilled to
accommodate a 3/4" pin or bolt.
WD-TF
Single "T" Female
3.5 lbs.
Has two 1/2" tabs and is used with Outside Corner Male or
Single "T" Male connectors. Can be bolted to seawall for
hinging ramps or to the side of a dock for finger attachment.
WD-B
5" x 5" x 1/4" Backup Plate
1.75 lbs.
Used to backup Single "T" Female and Single "T" Male
connectors. The backup is also used for backing Chain Retainers.
WD-A
Angle
1.75 lbs.
Used for attaching cross stringers to side stringers. Two Washer
Plates are used with each Angle to sandwich lumber and
provide a solid connection.
WD-W
Washer Plate
.5 lbs.
Used with Angles and Cleat Angles. The wood is sandwiched
between steel, providing greater strength.
800-223-3444
1/4"
SINGLE "T" MALE
WD-WPS15
9/16" Slotted Washer Plate
WD-WPS34
3/4" Slotted Washer Plate
1/4" high strength carbon steel
Hot-dipped galvanized
3/4" male tabs 1/2" female tabs