19
RESIDENTIAL WOOD DOCK HARDWARE
Residential wood dock hardware is the perfect solution for building a dock for
calmer areas. Used with smaller boats and in areas that are protected such as
lakes and ponds. 3/16" carbon steel hot-dipped galvanized to ensure long life.
This hardware uses 3/8" carriage bolts.
RWD-E
Residential Outside Corner End
5 lbs.
Outside Corner Ends are used at the end of docks, ends of finger
docks, swim float corners, or when plain ends are needed.
RWD-IN
Residential Inside Corner
5 lbs.
Inside Corners with corner gussets are used as an inside
backup for the Outside Corner hardware. The corner gussets
provide strength and help reduce racking.
RWD-M
Residential Outside Corner Male
6.5 lbs.
Has one 3/4" tab and is used with RWD-F Outside Corner Female
or RWD-TF Single "T" Female connectors. The tabs are pre-drilled
to accommodate a 3/4" pin or bolt.
RWD-F
Residential Outside Corner Female
6.5 lbs.
Has two 1/2" tabs and is used with RWD-M Outside Corner
Male or RWD-TM Single "T" Male connectors. The tabs are pre-
drilled to accommodate a 3/4" pin or bolt.
RWD-A
Residential Angle
1.25 lbs.
Used for attaching cross stringers to side stringers. Two RWD-W
Washer Plates are used with each Angle to sandwich lumber
providing a solid connection.
800-223-3444
RWD-W
Residential Washer Plate
.5 lbs.
Washer Plates are used with RWD-A Angles and RWD-CA Cleat
Angles. The wood is sandwiched between the steel providing
greater strength.
3/16"
RESIDENTIAL ANGLE