12
WOOD DOCK HARDWARE
The Ramp Roller Kits shown below can be used on a tapered truss frame
to create a rolling ramp. The non-rolling end of the ramp can use standard
connecting hardware to attach to the dock or a fixed structure.
Tapered Truss Frames can be found on page 34.
WD-FDS135
Finger Deck Stabilizer 135
4.5 lbs.
Using our WD-FDS45 and WD-FDS135, you can construct a finger deck stabilizer. This assembly helps stabilize narrow fingers by spreading
the load onto the main dock. The WD-B Backup Plates are used as backups to the "T" (not included).
WD-FDS45
Finger Deck Stabilizer 45
8.25 lbs.
WD-BAR56
5' to 6' Wide Ramps
25 lbs.
Building a roller ramp has never been easier with our Ramp Roller Kit. The WD-BAR34 fits 3' to 4' wide ramps and comes with
two Rollers
and
two WD-E Outside Corner Ends. The WD-BAR56 fits 5' to 6' wide ramps and comes with three Rollers, two WD-E Outside Corner Ends,
and
one WD-W Washer Plate.
WD-RP1
Roller Assembly
10 lbs.
Ideal for those areas where a sturdy roller assembly is needed.
Sold as single units.
Ramp Roller Kit
WD-BAR34
800-223-3444
WD-BAR34
3' to 4' Wide Ramps
23 lbs.
1/4"
FINGER DECK STABILIZER 135
RAMP ROLLER KIT