13
WOOD DOCK HARDWARE
3/4" male tab, 1/2" female tabs are used to ensure strength. Wood as thick
as 3" can be used. We would normally recommend 2" x 8" for side stringers
as a minimum.
WD-SP
Splice Plate Set
29.25 lbs.
Splice Plate Sets are designed to join two side stringers together to make longer dock sections. The flat plate is used on the outside of
the stringer and the "T" plate is used on the inside of the stringer. The "T" plate will attach to the cross stringer as shown. Set includes a
flat plate, a "T" plate, and a Backup Plate.
WD-RCP6
Ramp Cover Plate Set (66.5")
68 lbs.
Ramp Cover Plates are designed to cover the gap created by the male/female hardware between the ramp and shore by providing a
covered walking surface between the sections. One side is pre-punched and will bolt through the deck surface. The opposite side will
slide with the movement of the dock.
800-223-3444
WD-RCP4
Ramp Cover Plate Set (42.5")
41 lbs.
Ramp Cover Plate Set
Splice Plate Set
WD-RCP3
Ramp Cover Plate Set (30.5")
28 lbs.
1/4"
CUSTOM RAMP COVER PLATE