21
NON-ARTICULATING WOOD DOCK HARDWARE
Non-articulating Wood Dock Hardware is designed to reduce the movement
between dock sections, while providing additional stability. All hardware is made
from 1/4'' steel and is hot-dipped galvanized for long-lasting service. These
components along with our HD Wood Dock Hardware will allow you to construct a
dock using single or double 2" treated nominal lumber.
WD-NAE
Non-Articulating Outside Corner End
7.5 lbs.
Outside Corner Ends are used at the end of docks, ends of finger
docks, swim float corners, or when plain ends are needed.
Outside Corner Ends are backed by WD-NAIN Inside Corners.
WD-NAM
Non-Articulating Outside Corner Male
8 lbs.
Has one 3/4" tab and is used with WD-F Outside Corner Female
or WD-TF Single "T" Female connectors. The tabs are pre-drilled
to accommodate a 3/4" pin or bolt.
WD-NAIN
Non-Articulating Inside Corner
6.5 lbs.
Non-Articulating Inside Corners with corner gussets are used as
an inside backup for the Outside Corner hardware. The corner
gussets provide strength and helps reduce racking.
WD-NAB
Non-Articulating Backup Plate
1.75 lbs.
Backup Plates are used as a set to connect non-articulating
finger docks into the side of main dock sections.
800-223-3444
F-HB7S
3/4" x 7" Stainless Hex head Bolt & Nylon Lock Washer
1.50 lbs.
F-HB5S
3/4" x 5" Stainless Hex Head Bolt & Nylon Lock Washer
1.25 lbs.
WD-UD4
Urethane Donut Spacer 1" x 4" Diameter
.5 lbs.
1/4"
N.A. INSIDE CORNER
WD-UD4 1" x 4" Urethane Donut Spacer allows minimum movement between
dock sections.
WD-UD4