11
WOOD DOCK HARDWARE
1/2" carriage bolts are utilized with our standard hardware. All our bolts are
hot-dipped galvanized to ensure long life. Our bolt prices are lower than your
neighborhood hardware store. Check out our bolt sets on page 45.
WD-CA
Cleat Angle
1.75 lbs.
The Cleat Angle is bolted to the inside of the side stringer and
uses a Washer Plate as a backup. The cleat is bolted through the
deck and through the Cleat Angle. The slotted holes allow for
various size cleats to be used. This cleat assembly ties your cleat
into the dock's framing and not just the deck board. We also offer
an XL Cleat Angle for cleats larger than 12". This would be used
in the same manner as the standard Cleat Angle. The Cleat Flat
Washer provides additional holding strength in areas a Cleat
Angle cannot be used.
800-223-3444
WD-FPS
Finger Pipe Stabilizer
24 lbs.
Our pipe-type finger dock stabilizer is an easy way to stabilize
your finger dock. We use two WD-TF Single "T" Females, two
WD-B Backup Plates, and 1.5" galvanized pipe. A 3/4" Bolt and
Nylon Lock Washer connect each end (included).
WD-CAXL
Cleat Angle XL
2 lbs.
WD-CAFW
Cleat Flat Washer
.50 lbs.
WD-CR
Chain Retainer
3.75 lbs.
These are typically bolted to the side of the dock or to a cross
stringer and can accommodate up to 1/2" chain to hold the dock
in place. Use a WD-B as the backup plate.
WD-PHCR
Chain Retainer XL
8 lbs.
These are typically bolted to the side of a dock and uses chain to
hold the dock in place. Use a WD-PHCRB as the backup plate.
WD-PHCRB
Chain Retainer XL Backup Plate
4.10 lbs.
Backup Plate for the WD-PHCR Chain Retainer XL.
1/4"
CLEAT ANGLE